9-4 Sterilization (Contra Angle Head)
Sterilize the Contra Angle Head by autoclave sterilization. Remove the file after each patient and sterilize as
noted below.
) Insert into an autoclave pouch. Seal the pouch.
2) Autoclavable under the conditions below.
Autoclave for more than 20 min. at 2°C, or 5 min. at 32°C, or 3 min. at 34°C.
3) The Contra Angle Head should remain in the autoclave pouch until required for use.
•
Only the Contra Angle Head may be sterilized.
•
Do not autoclave the product with other instruments even when it is in a pouch. This is to
CAUTION
prevent possible discoloration and damage to the product from chemical residue on other
instruments.
•
Keep the product in suitable atmospheric pressure, temperature, humidity, ventilation, and
sunlight. The air should be free from dust, salt and sulphur.
•
Immediately after use, the product should be cleaned, lubricated and sterilized. If blood
remains on the external or internal surfaces it can become clotted and cause rust.
•
Do not heat or cool the product too quickly. Rapid change in temperature could cause
damage to the product.
•
If the sterilizer chamber temperature may exceed 35°C during the dry cycle then delete the
dry cycle.
•
Autoclave sterilization is recommended for the product. The validity of other sterilization
methods is not confirmed.
•
Do not touch the product immediately after autoclaving as it will be very hot and must remain
in a sterile condition.
NOTICE
•
NSK recommends Class B sterilizers as stated in EN3060.
10
Periodical Maintenance Checks
Perform periodical maintenance checks every three months, referring to the check sheet below. If any
abnormalities are found, contact your Authorized NSK Dealer.
Points to check
Looseness of the Head Cap
Rotation
Display
Check that the Head Cap is not loose.
Rotate the handpiece and check for abnormalities such as abnormal
rotation, vibration, noise, and overheating.
Immediately after the power is turned On, all the displays lights on the LCD
Panel should be on. Check if any of the displays lights are missing.
2
Details