Scan Mode; Measurement Range And Accuracy - Leica GEOVID 8x42 R Manual De Instrucciones

SCAN MODE

The Leica Geovid R binoculars can be used to
measure continuously. Holding down the release
button (5) the 2nd time it is pressed switches the
device to scan mode after around 0.5s and it
then performs continuous measurements. This
can be seen by a change in the display: Around
every 1.5s a new measured value is shown.
Scan mode is particularly practical for measuring
small targets.
Notes:
• Because of the continuous measurements,
power consumption is greater in scan mode
than for single measurements.
• After 10s, scan mode is automatically
deactivated to conserve the battery if the
button has been pressed unintentionally.
• In scan mode, the
EHr
for the last measurement.
value is only displayed

MEASUREMENT RANGE AND ACCURACY

The measuring accuracy of the Leica Geovid R
binoculars is up to ± 1 meter/yard. The maximum
range is achieved with well reflecting target
objects and a visual range of 10km. The
measuring range is influenced by the following
factors:
Range
Color of object
Angle to object
Object size
General
brightness
Atmospheric
conditions
Object structure
26
Longer Shorter
White Black
Perpendicular Acute
Large Small
Low (cloudy) High (midday
sun)
Clear Hazy
Homogeneous
Inhomogeneous
(wall of (bush, tree)
building)