Scan Mode - Leica GEOVID HD-B3000 Instrucciones

EN

SCAN MODE

6 1
46
6 3
7 2
Your Leica Geovid HD-B/HD-R can also be used for
continuous measurements (scan mode):
Hold the main/trigger button
2nd time. After about 2.5 seconds, the device
switches to scan mode and will then measure con-
tinuously. Scan mode is indicated by a change in
the display:
A new measured value appears every 0.5 seconds.
Scan mode is particularly useful for measuring the
distance to small, moving targets.
Notes
• In scan mode, the
AbC
shown only after the fi nal measurement.
• Because of the continuous measurements,
power consumption is greater in scan mode than
for single measurements.
when you press it a
1
compensation value is