17
Technical Information
How to Use by Front Panel
How to Use by Front Panel
Figure 29
The front panel START/STOP function is available only if the controller is set to
NOTE
"FRONT mode". If it is set to "REMOTE mode", when the key is pressed an error
message is shown indicating "COMMAND LOCKED IN REMOTE", if it is set to
"SERIAL" mode, the "COMMAND LOCKED IN SERIAL MODE" error message is
displayed. The "Reset Fail" function is always available regardless of controller
mode.
The front panel LOW SPEED function is available only if the controller is set to
NOTE
"FRONT"; otherwise an error message is returned. If it is set to "REMOTE"
mode, the COMMAND LOCKED IN REMOTE error message is displayed while if
it is in "SERIAL" mode the "COMMAND LOCKED IN SERIAL MODE" error
message is returned.
248/300
COUNTERS
increase
decrease
LOW SPEED
Start Stop and Reset Fail button
Press once for the START command and again for the STOP
command. In the case of controller's failure, press once to
reset the fail condition.
Low Speed
Press once to activate the LOW SPEED command; press
again to de-activate.
TwisTorr 84 FS AG Rack Controller User Manual / 87-901-037-01 (D)
LS
R1
AG
R2
VACUUM TECHNOLOGIES
MEASURES
next
menu
previous
START/STOP
TwisTorr 84 FS AG
Turbo-V 301-AG