Aligning The Running Belt (Fig. I); Adjusting The Running Belt Tension - Bremshey Sport RN2 Manual De Instrucciones

EN

Aligning the running belt (fig. I)

The running belt must run in the center of the rollers. If the running belt is pushed to
one side, the running belt must be aligned using the adjustment bolts at the rear of
the equipment.
CAUTION
– Make sure that the running belt is aligned correctly to prevent
damage to the edges of the running belt.
1. Set the mains power switch to the on position.
2. Set the speed to 5 km/h.
3. If the running belt runs in the center of the rollers, the running belt is aligned
correctly.
4. If the running belt drifts to the left, turn the left adjustment bolt 1/4 turn clockwise
and the right adjustment bolt 1/4 turn counterclockwise.
5. If the running belt drifts to the right, turn the right adjustment bolt 1/4 turn
clockwise and the left adjustment bolt 1/4 turn counterclockwise.
6. Repeat the last 2 steps until the running belt is aligned to the centre.

Adjusting the running belt tension

The running belt tension must be adjusted when it starts to slip on the rollers. The
running belt tension must be adjusted using the adjustment bolts at the rear of the
equipment.
CAUTION
– Make sure that the running belt is aligned correctly to prevent
damage to the edges of the running belt.
1. Set the mains power switch to the on position.
2. Set the speed to 5 km/h.
3. Turn both adjustment bolts 1/4 turn clockwise an equal amount of times.
4. Slow down the running belt by holding onto the side handlebars and braking as
you walk.
26 RN2