Publicidad
17
Technical Information
Serial Cable Installation
Serial Cable Installation
The supplied serial cable must be installed when the controller or the
optional vent valve have to be controlled by means of a remote
computer.
The cable is installed fixing the 9 pin D-type connector into the P2
serial connector as shown in the following figure.
Figure 18 Serial Cable Installation
TwisTorr Medium-TMP on-board Controller Installation
The controller can be mounted in two position:
bottom mounting (as per the complete system)
side mounting.
To install the controller execute the following procedures.
172/181
TwisTorr Medium-TMP on-board Controller User Manual / 87-901-050-01
Publicidad
Capítulos
