Publicidad
17
Instructions for Use
General Information
General Information
This equipment is destined for professional use. Before operating the
equipment, the user should read this instruction manual and any
other additional information supplied by Agilent. Agilent declines
any responsibility for non-compliance, even partial, with these
instructions, improper use by untrained persons, unauthorized
repairs of the equipment or use not complying with specific national
standards. The TwisTorr Medium-TMP on-board Controller is suitable
for use with TwisTorr 404/704/804 FS pumps. It is equipped with
auxiliary connectors that make it possible to power an additional fan,
to control the vent valve and for remote operation of the TwisTorr
Medium-TMP on-board Controller by a host computer connected on a
serial line (RS232 or RS485). The following paragraphs contain all
the information necessary to guarantee operator safety when using
the equipment. For detailed information, refer to the "Technical
Information" appendix.
The following conventions are adopted in this manual:
Caution messages are displayed before procedures which, if not followed, may
CAUTION!
cause damage to the equipment.
WARNING!
Warning messages are intended to draw the operator's attention to a
particular procedure or practice which, if not followed correctly, may cause
serious injury.
134/181
TwisTorr Medium-TMP on-board Controller User Manual / 87-901-050-01
Publicidad
Capítulos
