Optional Serial Port
Serial Port Installation
An optional RS 232/422/485 kit is available for both models. To
install it, proceed as follows:
Figure 14
Turbo-V 1000HT PCB Controller User Manual / 87-900-906-01 (F)
Switch off the power
Attach the interface board connector to connector P6 on
thecontroller and then secure it in place using screew A (3x6),
which is not provvided..
Insert the flat cable and plug it into the socket P1 located on the
Interface board.
Serial port connector installation
Technical Information
Optional Serial Port
217/262
17