Festo DNCI Serie Instrucciones De Utilizacion página 22

DNCI−...
Make sure that the compressed air is cor
S
rectly prepared (here: filtered, dried and
non−lubricated / see 'Technical specifica
tions').
Once a medium has been selected, keep
S
this unchanged over the complete service
life of the product (media quality see
'Technical specifications').
Pressurize your complete system slowly
S
until the operating pressure is reached.
All movements of the actuators will then
be controlled.
For slow start−up pressurization use
safety start−up valve type HEL−... or
HEM−... .
Use the DNCI−... in its original state without undertaking any modifications.
S
5 Fitting
Fitting mechanical components
Check the use of the DNCI−...
S
as a measuring cylinder
with electronic control.
Please note
Using the DNCI−... with electronic control:
S Use the DNCI−... only in the approved mounting positions (see here the drive−
specific information on the controllers type SPC...).
S Take into account the mounting specifications and instructions especially for
the DNCI−... in the manual for the controllers type SPC... .
Make sure that tubing and connection accessories have sufficient space for
S
movement.
22
Fig. 3
Fig. 4
Festo DNCI−... 0610a English