Reloading Applicator; Cold Cartridge Reload - 3M Scotch-Weld PUR Easy 250 Manual Del Usuario

Reloading Applicator

Cold Cartridge Reload

Caution
!
Avoid contact with hot adhesive,
cartridge, applicator tip, and metal
components. May cause burns.
IMPORTANT: Wear heat resistant
gloves and safety glasses when using.
WARNING
!
Use only 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges. Use with
any other material may cause
hazardous conditions.
© 3M 2014
Adhesive will resist flowing through applicator if total heat history of adhesive
cartridge at application temperature exceeds 16 hours (total time in
preheater and in applicator). Properly discard any adhesive cartridge that has been
heated longer than 16 hours and replace with a new, heated cartridge.
1. If applicator is cold, turn it on and allow to heat for five (5) minutes.
2. Unscrew and remove end cap from applicator.
3. Remove empty cartridge with attached disposable nozzle from applicator and discard.
Inspect nozzle housing for adhesive build-up and clean if needed. Replace nozzle
housing into the applicator.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
Important
9