Loading Applicator And Dispensing With New Cartridge - 3M Scotch-Weld PUR Easy 250 Manual Del Usuario

Loading Applicator and Dispensing
with New Adhesive Cartridge
WARNING
!
Use only 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges. Use with
any other material may cause
hazardous conditions.
WARNING
!
3M™ Scotch-Weld™ Polyurethane
Reactive (PUR) Easy 250 or 3M™
Scotch-Weld™ Polyurethane Reactive
Adhesive Cartridges should be
preheated or used in 3M™
Scotch-Weld™ Polyurethane Reactive
(PUR) Easy 250 Adhesive Preheater or
3M™ Scotch-Weld™ (PUR) Easy 250
Adhesive Applicator only. Do not
preheat 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
or 3M™ Scotch-Weld™ Polyurethane
Reactive Adhesive Cartridges in ovens
or other heating devices or use in
other applicators. May cause
hazardous conditions.
Caution
!
Avoid contact with hot adhesive,
cartridge, applicator tip, and metal
components. May cause burns.
IMPORTANT: Wear heat resistant
gloves and safety glasses when using.
6
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
1. Remove end cap and insert adhesive cartridge without puncturing or attaching
disposable nozzle into applicator as shown.
2. Tighten applicator end cap to ensure a positive seal. Allow cartridge to warm for a
minimum of 45 minutes.
3. Remove adhesive cartridge and place on a bench or flat work surface with threaded
nozzle pointing upward. Allow cartridge to stand for approximately 60 seconds.
4. Place a rag or paper towel around or near the nozzle portion of the cartridge.
5. Place a punch or similar tool into the nozzle portion of the cartridge as shown.
Note: For best results, hang the
applicator from a tool balancer or
stand up by means of the wire stand
or bench mount.
© 3M 2014