Setup And Installation - 3M Scotch-Weld PUR Easy 250 Manual Del Usuario

Setup and Installation

Caution
!
Do not connect the applicator to air
supply with greater than 80 psi air
pressure. May cause hazardous
conditions or damage the applicator.
IMPORTANT: For disposal of adhesive
or adhesive components, please read
and follow information found on the
selected 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
Adhesive MSDS.
WARNING
!
Use only 3-prong grounded plug and
properly grounded outlet. Failure to
use properly grounded plug and outlet
may cause electrical shock.
IMPORTANT: If you are not sure of
proper connections, get help from a
qualified electrician or service person.
WARNING
!
Do not use an unapproved extension
cord with the applicator. Use an
extension cord which complies with
NEC requirements and state and local
codes and other requirements.
4
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
1. Remove the applicator from its shipping container and inspect for any obvious
damage. If damaged, do not use and immediately contact your local 3M
representative.
2. Connect air coupling provided on the end of the supply hose (male 1/4-inch pipe
thread) to a filtered, regulated and dry air supply. (Regulator and filter not
included.)
Filter/Dryer
3. Adjust air regulator to an 80 psi starting point.
4. Plug applicator into grounded receptacle.
© 3M 2014