3M Scotch-Weld PUR Easy 250 Manual Del Usuario página 29

WARNING
Do not clean or remove 3M™
Scotch-Weld™ Polyurethane Reactive
(PUR) Easy 250 or 3M™ Scotch-Weld™
Polyurethane Reactive Adhesive with
heat, flame, or solvent. May cause
hazardous vapors or fire.
© 3M 2014
4. Cured adhesive in the disposable nozzle could cause adhesive flow to
become slow or stop.
5. Remove old plugged disposable nozzle and install new disposable
nozzle.
6. If air flow to end cap does not occur when trigger is pulled, check to see
that applicator is properly connected to a pressurized air regulator. If
connections are properly made and pressure is at 30 psi minimum,
proceed to next step.
7. Remove end cap from applicator. Place a 7/16-inch open end wrench on
swivel fitting. Hold fitting with wrench and turn end cap in direction of
arrow in diagram. Remove end cap and set aside.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
27