3M Scotch-Weld PUR Easy 250 Manual Del Usuario página 25

WARNING
!
Disconnect air and electrical power
and make sure applicator has cooled
to room temperature before servicing.
Failure to disconnect air and electrical
power or failure to allow applicator to
cool before servicing may cause
electrical shock or burns. Read
User's Manual before servicing.
© 3M 2014
Disassembly Procedure
9. Remove power cord from grounded electrical outlet and disconnect air supply.
10. Remove wire stand by pulling one side just enough to clear wire out of its pivot hole.
Let the wire settle into the recess just forward of the pivot hole location.
11. Repeat the above procedure on the opposite side of the applicator.
12. Pull either side of the wire stand over the housing, preferably at the lowest point –
which is the small groove at the front. Remove the wire stand and set aside.
13. Remove end cap by turning it counterclockwise.
14. If possible, remove cartridge with attached nozzle from applicator.
15. Lay applicator on side so screw heads face upward.
16. Unscrew all twelve (12) Phillips head screws.
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
23