3M Scotch-Weld PUR Easy 250 Manual Del Usuario página 10

Loading Applicator and Dispensing
with New Adhesive Cartridge (continued)
WARNING
!
Do not heat or expose 3M™
Scotch-Weld™ Polyurethane Reactive
(PUR) Easy 250 or 3M™
Scotch-Weld™ Polyurethane
Reactive Adhesive to temperatures or
surfaces above 275°F (135°C).
Vapors of heated material may be
irritating to eyes and respiratory
tract and may cause asthma-like
symptoms in persons previously
sensitized to isocyanates.
Caution
!
Do not connect the applicator to air
supply with greater than 80 psi air
pressure. May cause hazardous
conditions or damage the applicator.
IMPORTANT: For disposal of adhesive
or adhesive components, please read
and follow information found on the
selected 3M™ Scotch-Weld™
Polyurethane Reactive (PUR) Easy 250
Adhesive MSDS.
WARNING
!
Do not clean or remove 3M™
Scotch-Weld™ Polyurethane Reactive
(PUR) Easy 250 or 3M™
Scotch-Weld™ Polyurethane Reactive
Adhesive with heat, flame, or solvent.
May cause hazardous vapor or fire.
For additional health and safety
information, see product label and
Material Safety Data Sheet for
Scotch-Weld Adhesive used.
IMPORTANT: For additional health and
safety information, see product label
and Material Safety Data Sheet for
Scotch-Weld Adhesive used.
8
3M™ Scotch-Weld™ Polyurethane Reactive (PUR) Easy 250 Adhesive Applicator User's Manual
1. Activate the trigger on the applicator for adhesive application. For best results, set the
air pressure at 80 PSI to start flow.
2. Adjust for desired adhesive flow rate by setting air regulator between 30 psi
and 80 psi.
For best results, hang the applicator from a tool balancer or stand up by means of the
wire stand or bench mount.
Wire Stand
Benchmount Bracket
Assembly
62-9895-9950-1
Note
Tool Balancer
Benchmount Foot
Valve Assembly
62-9277-9930-4
Note: Bracket Does
NOT come with stand.
© 3M 2014