Espresso- And Mocha Preparation - Beem M300-F Manual De Instrucciones

6.2

Espresso- and Mocha preparation

Fig. 11 Remove the jug (8) from the water tank (15) by screwing it anticlockwise.
Fig. 12 Screw the espresso valve (2) onto the riser tube (4) in the jug.
Fig. 13 Remove the coffee funnel (12/13) from the water tank (15).
Fig. 14 Fill the water tank (15) to mark 3 or mark 6 (max.) with clean cold tap water.
Fig. 15 Insert the coffee funnel (12/13) in the water tank (15). For 3 cups use the
small coffee funnel (13) and for 6 cups use the large coffee funnel (12).
Fig. 16 Place the ground coffee in the coffee funnel (12/13). The funnel has to be filled
with coffee to just below the rim. Distribute the coffee evenly in the filter. Do
not compress the coffee too much, but simply remove any excess from the top.
When you use mocha powder the coffee funnel (12/13) may only be filled
loosely with the mocha powder. Make sure that there is no ground coffee on the
rim of the filter or on the thread. Put the top filter (11) on the coffee funnel
with the fine strainer pointing downwards.
Fig. 17 Place the jug (8) onto the water tank, holding it straight. Turn the jug clockwise
to secure it to the water tank. When positioning the jug on the water tank,
ensure that the dot on the jug is aligned with the bar on the water tank. You
can also add sugar or sugar cubes to the pot (8), depending on your taste.
Fig. 18 Close the lid. Place the espresso maker on the power supply base (17).
Fig. 19 Press the power switch (16). The indicator light (16) switches on. After a few
minutes, the coffee begins to fill into the jug. There will be loud noises on
account of the high pressure of our coffee machine. The brewing process is
completed when the indicator light is off. Wait several seconds until the rest of
the coffee has come out. Remove the espresso maker from the base and when
pouring, open the lid by pressing slightly on the lid tab (6), otherwise it will drip
when pouring and some coffee will run down the jug.
NOTE: When pouring out, open the lid (5) by pressing slightly on the lid tab (6).
ATTENTION: Allow the espresso maker to cool down completely before
removing the container from the tank. The container and the tank may still
contain hot water!
NOTE: If you wish to brew another portion of espresso coffee, you have to wait
until the boiler has cooled down completely. The appliance will not work while it
is still hot. The touch key is temperature-controlled and automatically switches
off the appliance until it has cooled down completely. It cannot be switched on
again until then. Do not block the touch key in order to force the machine to
brew more coffee before it is ready.
BEEM – Elements of Lifestyle 22 / 68