Descaling; Malfunctions And Troubleshooting - Beem M300-F Manual De Instrucciones

7.2

Descaling

Hints and tips:
The service life of the appliance will be extended if you descale the unit on a regular
basis. The length of the descaling intervals depends upon the hardness of the water.
If you use a commercially available descaler please also observe the instructions
provided by the manufacturer.
1. Pour around 300 ml of water into the tank and add the descaler with citric acid or
vinegar essence (approx. 5% acid).
2. Perform a brewing process until the descaler has passed through the unit.
3. Rinse the water tank thoroughly.
4. Allow the machine to brew two tank-fulls of clear water through the unit.
5. Rinse all parts in hot water and washing-up liquid before using the unit to produce
espresso again.
8

Malfunctions and troubleshooting

DANGER: Pull out the mains plug in the event of malfunctions during operation.
Fault
Signal lamp does not light
up
The unit is not producing
espresso
The espresso takes a very
long time to produce or the
unit switches off
Main fuse pops out
BEEM – Elements of Lifestyle
Possible cause
Mains plug not inserted
No mains voltage
On/Off switch faulty
Signal lamp defective
No water in the tank
The coffee is pressed down
too much
Filter disc, riser tube or
valve jet is blocked
Appliance defective
Too many appliances
connected
Remedy
Connect appliance to the
power supply
Check main fuse/power
socket
Replace switch
Inform customer service
Add water
Do not compress the
ground coffee too much
Clean the parts as
described in chapter 7
Inform customer service
Reduce number of
appliances in the electric
circuit
24 / 68