Sola NS PLUS 2311 Manual Del Usuario página 24

STARTING
Once the seed drill is coupled with the tractor, THE PTO SHAFT SHOULD
BE ADAPTED:
1- Dismount and insert one end into the tractor's universal joint shaft and the
other end into the seed drill.
Look for the minimal movement length "L" (fig. 8) by raising and lowering
the hydraulic lift.
2- Cut the spare plastic and metal into parts of the same length and remount
the PTO shaft.
3- Operate the hydraulic lift and check that the PTO shaft's movement is correct.
4- Secure the PTO shaft using the chain.
WHEN OPERATING THE PTO
SHAFT CHECK THAT THE ENGINE
IS OFF. ALWAYS WORK WITH THE
PTO SHAFT PROTEC TED AND
IN GOOD CONDITION. PREVENT
THE PTO SHAFT'S TUBE FROM
TURNING BY SECURING IT WITH
THE CHAIN PROVIDED.
WHEN LOWERING THE SEED DRILL TO THE GROUND, UNPLUG THE
TRACTOR'S UNIVERSAL JOINT SHAFT SO THAT THE PTO SHAFT DOES NOT
HAVE AN EXCESSIVE INCLINATION (MAX. 35º).
When holding the tractor universal joint shaft's clutch in, perform it gently.
STARTING SUDDENLY COULD SERIOUSLY DAMAGE THE SEED DRILL.
Fig. 8 Fig. 8
24
Fig. 9 Fig. 9
Fig. 10 Fig. 10