Battery Instructions - Max RB655 Manual De Operación Y Mantenimiento

4. BATTERY INSTRUCTIONS

Pack cap
Latch
Battery pack
Charger
Orange
standby lamp
Red charging lamp
When the orange standby light is lit
When the Battery pack is hot (after continuous use or exposure to direct sunlight) the Charger will
automatically switch to standby to protect the Battery. The orange standby light will blink until the
Battery's temperature lowers to a safe level, The Battery will then be charged automatically.
When the Battery pack is at low temperature
When the Battery pack is at low temperature, its charging is automatically suspended until its
temperature increases, in order to protect it, even if it is set in the Charger.
Leave the Battery pack at normal temperature in the room for some time, and then, charge it again.
Charging
1
WARNING:
Before removing the Battery pack from the tool, set the Main switch at OFF and
●
lock the Trigger.
q A Pack cap that is used to prevent short circuits must be removed from the terminal
of the Battery pack.
When charging the Battery pack, remove it by pushing on its latches from both sides
while firmly holding the grip of the tool.
w Connect a power cord to the charger.
Plug the Charger into AC 110-120V wall socket.
The red light, a current-carrying indicator, blinking.
AC
11