Technical Data; Consumable Parts - Max RB655 Manual De Operación Y Mantenimiento

4. TECHNICAL DATA

q NOISE
A-weighted single-event ------ LWA, 1s, d 89.3 dB
sound power level
A-weighted single event ------ LpA, 1s, d 79.1 dB
emission sound pressure
level at work station
These values are determined and documented in accordance to EN12549 : 1999.
w VIBRATION
Vibration characteristic value ＝ 0.53 m/s
These values are determined and documented in accordance to ISO 8662-11.
This value is a tool-related characteristic value and does not represent the influence to the hand-arm-system when using the
tool. An influence to the hand-arm-system when using the tool will, for example, depend on the gripping force, the contact
pressure force, the working direction, the adjustment of main supply, the workpiece, the workpiece support.
e RADIATED EMISSION 30-1000 MHZ
Class B
5. APPLICATIONS
＊ Construction works (bridge, road, etc.)
Commercial building
＊ Making pre-cast concrete products.
＊ Building floor and wall.
6. RECOMMENDED REINFORCING BAR COMBINATION CHART
The minimum bar size combination
#3 × #3 ( φ 10 mm × φ 10 mm)
The maximum bar size combination
#9 × #8 ( φ 29 mm × φ 25 mm)
＊ The total diameter of the re-bars must be less than 2-1/2" (65 mm).
＊ The diameter of reinforcing bar combination should be from 3/4" ( φ 20 mm) to 2-1/2" ( φ 65 mm).

7. CONSUMABLE PARTS

The parts shown below are consider normal wearing parts.
Motors
Battery pack (JP509H)
2
Cutter
Springs
Gears
5