Max RB655 Manual De Operación Y Mantenimiento página 18

45°
Arm
Centerline
During tool operation
Do not move the equipment to the next tying position until the current tying operation has been
●
completed.
During the tying work (while the machine is operating), there will be a slight pull on the equipment
●
because the hook will twist the binding wire. For this reason, securely grasp the grip during operation.
The Tip of
Tie-Wire
For proper tightness
4
q Tilt the Arm 45° to the intersecting part of the re-bars and push it against them
securely.
w Apply the tool perpendicularly to the surface of the crossed re-bars.
Make the centerline part touch the center of the crossed re-bars.
e Tie in alternate direction.
r Cross tie
If you need the cross tie, bend the tail of the first tie before making the second tie.
If the tip of the Tie-Wire is deformed, the Hook may not catch the wire and this could
result in failure of tying. If this happens, lock the Trigger, turn the Main switch off and
then turn it on again. This re-initialization feeds and cuts the wire automatically.
Remove the cut end of wire with pliers, unlock the Trigger and try tying again.
18