fluidra 65542 PROHEAT II 35KW Manual Técnico, Arranque Y Funcionamiento página 33

PROHEAT II SERIES · AIR/WATER SYSTEM
•
Repeat the process to program periods 2 and 3 (if necessary).
•
Press to pass through all the periods and exit the menu.
NOTE: If the Schedule Program mode is activated and there are no periods scheduled,
the machine will not start.
5. Setting the machine operating mode
•
Press to choose the machine operating mode (Heat, Cool and Automatic, only if
F29=3).
•
Press for at least 2 seconds to activate or deactivate the Schedule Programming
mode.
6.
Checking the temperatures (Reading variables)
•
Press to display the temperature probe settings and compressor consumption
(3 settings for each phase of the compressor). Use
settings.
The values shown refer to the following nomenclature:
1. WATER INLET TEMPERATURE
2. COIL 1 TEMPERATURE
3. COMPRESSOR 1 DISCHARGE TEMPERATURE
4. COIL 2 TEMPERATURE
5. COMPRESSOR 2 DISCHARGE TEMPERATURE
6. AIR TEMPERATURE
7. WATER OUTLET TEMPERATURE
8. CURRENT PHASE 1-COMPRESSOR 1
9. CURRENT PHASE 2-COMPRESSOR 1
10. CURRENT PHASE 3-COMPRESSOR 1
11. CURRENT PHASE 1-COMPRESSOR 2
12. CURRENT PHASE 2-COMPRESSOR 2
© FLUIDRA 2016 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
ENGLISH
or to display the various
Pag: 33