General Precautions; Checking The Packaging - fluidra 65542 PROHEAT II 35KW Manual Técnico, Arranque Y Funcionamiento

PROHEAT II SERIES · AIR/WATER SYSTEM
13. CURRENT PHASE 3-COMPRESSOR 2
NOTE: The compressor consumption settings vary depending on water and outside
temperature and the settings of phase consumptions does not have to be the same.
7.
Blocking the keypad
•
Press and
display. The blocked icon will appear on the screen. Press another 5 seconds to
unblock the keys.
8. Manual Reset
• Press

7. GENERAL PRECAUTIONS

The installation, start-up and maintenance operations must be performed by qualified
personnel.
This equipment should not be installed in inflammable or explosive environments.
The electrical power supply at the main circuit breaker must be switched off before any
maintenance work is performed inside the machine.
It is mandatory to use personnel protection equipment, such as goggles, gloves, etc. during
maintenance work.
During operation of the unit, it is normal that the condensation produced in the evaporation
battery will produce a certain quantity of water which will have to be evacuated. The machine
is equipped with a drain for this purpose that must always be unobstructed.
Esta agua de condensación no tiene que ser tratada de una forma especial.

8. CHECKING THE PACKAGING

This equipment comes with RECYCLABLE packaging that can withstand rough transport
conditions. However, you should examine the device during installation to ensure there is no
damage, thus avoiding any subsequent malfunction.
The MANUFACTURER will not be held responsible in this case.
© FLUIDRA 2016 ALL RIGHTS RESERVED. PROPRIETARY DOCUMENT.
at the same time for 5 seconds to block the buttons on the
to switch the machine ON and OFF.
ENGLISH
Pag: 34