Connection To Power Supply; 12- Configuration - Jusan TAX-LINE Manual Del Usaurio

Below you will find the configuration of the unit's 9 pin connector. The V24 connector
configuration will of course depend on the exact model of your PBX:

11.2 Connection to power supply

Connect the adapter supplied to the mains and to the POWER jack located at the
rear of the unit.
The unit must be connected to the mains in order to operate. The internal battery is
only used to power the memory, and to sustain the data and configuration in the case
of a mains failure.

12- CONFIGURATION

When the unit is connected to the mains for the first time, the following screen
appears:
Ext: maximum number
of extensions.
INSTALLATION
In the case of duration-based costing, indicates the
name of the tariff table present in the system and its
creation date.
If this screen does not appear, the system should be initialised again. Please refer to
the "resetting the unit" section in the Programming Guide.
Unit
RXD (2)
TXD (3)
DTR (4)
GND (5)
Indicate mode selection:
B stands for Business
H stands for Hotel
G stands for Guest Version
UNIT
ext:128 Call:10990
TARIFF
PBX
TXD
RXD
RTS
GND
4.XX B
DDMMYY
24
INSTALLATION
Calls: maximum
number of calls.