ROBBE Arcus E 2.2 ARF Manual De Construcción Y De Uso página 3

Fig. 1
- The picture shows the set contents of the Arcus E 2.2.
Fig. 2
- Connect the pre-formed end of the pushrod to the elevator
horn.
Fig. 3
- Attach the tailplane to the mount on the fin using the two
M3 x 12 mm screws.
Fig. 4
- Now slide the wing joiner spar into one wing panel.
Take care to use the correct end, as shown in the pho-
tograph.
Fig. 5
- Fit the wing, at the same time threading the two servo
leads (aileron and airbrake servos) through the fuselage,
as shown in the picture.
Fig. 6
- Now slide the second wing panel into place, following
exactly the same procedure as described in Step „5".
Fig. 7
- Once the wings are in place, attach them to the fuselage
using the M4.0 x 20 mm screw.
Fig. 8
- Tighten the wing joiner screws on the underside of the
wings for additional security.
Fig. 9
- Now connect the aileron servo leads and the airbrake ser-
vos using two Y-leads.
Take care to maintain correct polarity when connec-
ting the leads.
Building and Operating Instructions - Arcus E 2.2 ARF
Fig. 10
- Wiring diagram for control functions, retractable po-
wer unit, airbrakes and retractable undercarriage
(the stated channel assignment is correct for robbe Futaba
receivers)
1. Connect the servos to the receiver.
2. Connect the mixer to the speed controller.
10 Aileron Aileron
servo 1 servo 2
Channel 1 (Y-lead)
(speed controller)
LiPo battery
Elevator Rudder Retract
servo servo servo
Channel 2 Channel 4 Channel 5
ESC
Retractable power unit mixer
Retractable power
unit servo
No. 2568
Airbrake servo 1 Airbrake
servo 2
Channel 6 (Y-lead)
Channel 7
1 2 3 4 5 6
3