Festo DMES Serie Instrucciones De Utilizacion página 26

DMES−...
7. Fasten the coupling housing to the
DMES−... with the maximum number of
screws. (torque: see Fig. 8).
8. Press the clamping element (see Fig. 1)
into the hole on the side of the coupling
housing.
9. Press the motor with correctly placed
coupling hub into the coupling housing
(if necessary turn the motor).
10. Tighten the screw of the clamping
element (torque see Fig. 8).
Fitting the product
Please note
S Please note that in the case of heavy loadings the axis must not be
Note that the IP protection class will only be complied with if the product is
S
fitted correctly (protection against the penetration of dirt particles and drops).
Fitting position
Vertical, diagonal or horizontal with
cover band upwards
Diagonal or horizontal with cover
band downwards
Products with long stroke lengths:
Use the grooves as shown in Fig. 9 for
S
fastening the DMES.
26
fastened only by the front cover.
Heavy tensile strain may cause the screws in the cover to be pulled out.
dia. 25: 2.9 Nm
dia. 40: 5.9 Nm
Fig. 8
IP protection class
IP40
IP42
Ø40
Fig. 9
Festo DMES−... 0505NH English
DME−KG−25: 1.2 Nm
DME−KG−40: 9.9 Nm
Ø25