Selecting Frequencies In The Frequency Screen; Editing The Receiver Name - AKG WMS 4000 Modo De Empleo

3 Setting Up
3.8.4 Selecting Frequencies
from the Frequency Screen
3.8.5 Editing
the Receiver Name
32
- Press the SETUP control briefly. The display will revert to the Preset screen.
1. In SETUP mode, turn the SETUP control CW or CCW to call up this screen:
2. Press the SETUP control briefly. The display will change as follows:
3. To select the desired frequency, turn the SETUP control CW or CCW.
4. Press the SETUP control briefly. The display will change as follows:
• To save your setting, press the SETUP control briefly. The display will revert to the Frequency screen.
• If you'd rather not save your setting, turn the SETUP control CW or CCW. The display will change as
follows:
- Press the SETUP control briefly. The display will revert to the Frequency screen.
This screen lets you edit the current name of the receiver. If you have not named the receiver yet or delet-
ed its previous name, this screen will not be available. The EXTRA screen, however, allows you to save
Note: a new name at any time (refer to section 4.3.1).
1. In SETUP mode, turn the SETUP control CW or CCW to display the current name of the receiver:
The receiver name may be any combination of six letters and/or numbers.
2. Edit the current name
• Press the SETUP control briefly. The first character will start flashing:
• To change the first character turn the SETUP control CW or CCW.
• Press the SETUP control briefly. The second character will start flashing: