Mounting An Optional Strap; Fastening The Winch - AL-KO 351 Instrucciones De Uso

351, 501, 651D, 901, 901A, 1201A

Mounting an optional strap

Our winches can optionally be used with a with a spe-
cial loop strap instead of a rope. (
Caution!
The breaking load of the strap must be at least 7
times the specifi ed lifting capacity in the lowest
rope layer.
Observe the direction of the strap run-out - always
turn the crank handle in the "LIFT" direction!
Typ 351, 501, 901, 651D, 901A
1. Feed the AL-KO plug connection through the strap
loop.
2. Secure this with a washer, spring lock washer and
screw ( 9 -a).
3. Wind the strap in two full turns and mark the strap
run-out with colouring.
Typ 1201A
1. Feed the AL-KO plug connection through the strap
loop.
2. Secure this with a bolt and a hexagonal nut
( 10 -a).
3. Wind the strap in two full turns and mark the strap
run-out with colouring.
352860_b

Fastening the winch

Type
8)
351
501
651D
901
901A
1201A
Pulleys
The minimum diameter of the pulleys must be at least
12 times the diameter of the rope.

Angle of deviation
11
Fastening material
3 hex. head screws M8

3 washers 8 mm

3 hex. head. screws M10

3 washers 10 mm

4 hex. head screws M10

4 washers 10 mm

Example:
Rope strength Ø 7 mm

 Pulley Ø 84 mm
The angle of deviation (
than 4° when the rope is being wound in or out.
GB
Torque
25 Nm
49 Nm
49 Nm
a
11 -a) must be no more
13