Tabla de contenido
Publicidad
3.0 RULES OF USE
To obtain the best performance from the equipment, carefully
follow what is set out below.
The following maintenance, adjustment, and work preparation
operations must be performed with the tractor off and locked
firmly in position with the key removed from the dashboard
and the seeder positioned on the ground.
3.1 ATTACHMENT TO THE TRACTOR
The seeder may be attached to any tractor fitted out with a three-
point universal hitch.
The attachment to the tractor is a very dangerous phase. Be
very careful in following the instructions for the whole operation.
3.1.1 HOOKING
The correct positioning of the tractor/seeder is determined by
placing the unit on a horizontal surface.
1) Connect the seeder to the tractor's three point attachment;
the pins must be fastened with the appropriate pegs. Use the
adjustment stay-bolts (1 Fig. 8-9) to ensure that the seeder is
perpendicular to the ground (Fig. 8).
2) Block the movement of the parallels of the tractor on the
horizontal plane using the stabilizers provided, so eliminating
the side swaying of the equipment. Check that the tractor
hoisting arms are positioned at the same height from the
ground.
3) Adjust the height of the tractor lifting arms:
a) In the work position, adjust the path of the tractor hoisting
arms to guarantee adequate downward movement of the
planting unit. Otherwise, when hollows are encountered in
the seedbed, seed distribution could be irregular due to the
seed planting unit transmission wheels slipping (planing
effect).
b) in the transporting position, adjust the arms so that the seeder
does not, for any reason whatsoever, come into contact with
the ground.
4) Connect the Cardan shaft and make sure that it is perfectly
blocked on the power take-off Check that the protection turns
freely and fix it with the special chain.
5) The hydraulic pipes must be connected correctly to the tractor
distributors following the instructions on each pipe.
6) Check the length of the grain tubes (with the machine
completely hoisted) to avoid bendings and consequently
breaking of the tube, as well as the formation of loops (Fig.
10).
During the work, regularly check that the equipment is
perpendicular.
ATTENTION: Always follow the indications recommended by
the Manufacturer for the transport of the seeder.
cod. G19503360
ATTENTION
DANGER
USE AND MAINTENANCE
fig. 8
fig. 10
g
1
1
fig. 9
cod. G 19702401
ENGLISH
47
Publicidad
Tabla de contenido
