Stereo Receiver (Optional) - Jacuzzi J-300 Serie Manual De Instalacion Y Uso & Mantenimiento

Ocultar thumbs Ver también para J-300 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 80
I
Disconnect the power supply and remove the filter (and the
dispenser, if present; see "Dispenser for water sanitation").
Make sure that first you have reinstalled the filter before con-
necting the spa to the power supply and restarting the pump.
Poor jet action.
I
Press the JETS 1 button to make certain the pump 1 is on.
I
Place the air control in the "on" position.
I
Check that filter is not dirty and clean as necessary.
I
Make sure jets are fully open.
Water is too hot
I
Reduce temperature setting so the circulation pump turns off.
Water is too cold
I
Check temperature setting.
I
Keep the spa cover in place while heating.
I
Check the settings to see if your spa is in economy mode (see
chapter "Filter cycles").
Should checking the above steps fail to correct the problem,
please call an authorized dealer or service center.

Stereo receiver (optional)

BLUEWAVE™ Spa Stereo System
To start enjoying your new stereo receiver, please read the fol-
lowing operation instructions in their entirety.
1
1. Media Locker Handle
Slide the handle to lock and unlock the protective door.
2. Power On and Off
Press power button once to turn on stereo system. Press a sec-
ond time to turn off. Stereo can remain "On" in standby mode and
the red light will remain illuminated.
3. Auxiliary Input Jack Connector
Allows you to connect an auxiliary device by using a 3.5 mm ca-
ble.
4. Universal Serial Bus (USB) Device Connector
Allows you to connect your device via a USB port and a USB ca-
ble compatible with your device. Apple 30-pin cable supplied with
BLUEWAVE stereo.
5. Auxiliary Device Holding Base
The removable base securely holds the Auxiliary device, such as
an iPod/MP3/iPhone, in place. It can be removed for larger de-
vices.
6. 3.5 mm Cable
Use this cable to connect your Auxiliary or MP3 device to the
stereo via the "AUX" connection.
7. Apple 30-pin to USB Cable
Use this cable to connect your compatible iPod, iPhone or MP3
device to the stereo via the "USB" connection.
35
2
USB
AUX
3
4
5
6
7

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

J-315J-375J-385

Tabla de contenido