Electrolux EPI09LEIW Manual De Instrucciones página 8

7 www.electrolux.com
TIMER OFF Press this button to initiate the auto-off time sequence. Each
DIRECT
SWING
FRESH
SLEEP
SELF-
CLEAN
press will increase the auto-timed setting in 30 minutes
increments. When the setting time displays 10, each press
will increase the auto-timed setting 60 minutes increments.
To cancel the auto-timed program, simply adjust the auto-off
time to 0.0.
Used to change the louver movement and set the desired
up/down air flow direction. The louver changes 6° in angle
for each press.
Used to stop or start horizontal louver auto swing feature.
Press this button to enable or disable the clean air function. If
the clean air function is enabled the clean air symble on the
indoor unit display will be shown.
This air conditioner is equipped with ionizer or Plasma Dust
Collector(Depending on specific configuration of the model).
With the anions generated by Ionizer, the air circulation of the
air conditioner fills the room with refreshing, natural and
healthy air. The Plasma Dust Collector generates a high
voltage ionization zone, through which the air is converted to
plasma. Inside the air most of the dust, smoke, and pollen
particles are captured by the electrostatic filter.
Press the button to enable or disable the SLEEP function,
during AUTO, COOL or HEAT mode
If you enable SLEEP function under COOL mode, the air
conditioner will automatically increase setting temperature
1°C per hour for the first 2 hours, then hold steadily for
thenext 5 hours, after that it will switch off. This mode saves
you energy and brings you comfort at night.
If you enable SLEEP function under HEAT mode, the air
conditioner will automatically decrease setting temperature
1°C per hour for the first 2 hours, then hold steadily for
thenext 5 hours, after that it will switch off. This mode saves
you energy and brings you comfort at night.
Press the button to enable or disable the SELF-CLEAN
function, during AUTO (cooling), COOL or DRY mode.
The unit will operate as following sequence : FAN ONLY
mode at Low fan speed--Heating operation with LOW fan
speed(applicable to cooling & heating modles only) --FAN
ONLY operation--Stop Operation---Turn off.
This function is only available under COOL(AUTO COOL,
FORCED COOL) and DRY mode.