General Operation; Optional Operation; Special Functions - Electrolux EPI09LEIW Manual De Instrucciones

FOLLOW
ME
SHORTCUT Used to restore the current settings or resume previous

3.1. General operation

1. Disconnect the unit from the power
supply.
2. Press the ON/OFF button to start
the unit.
3. Press the MODE button to set the
operation mode.
4. Press the UP and DOWN buttons
to set the temperature. (Note: It is
unnecessary to set the
temperature in FAN mode.)
5. Press the FAN button to set the
fan speed.
6. Press the DIRECT and SWING
buttons to set the swing.
Before select the function, it is recommended to run the air
conditioner under Cooling operation for about half an hour.
Once the Self Clean function is activated, all TIMER setting
will be cancelled.
During Self Clean operation, when press the SELF CLEAN
button on the remote controller again will stop the
operation and turn off the unit automatically.
Push this button to initiate the Follow Me feature, the remote
display is actual temperature at its location. The remote
control will send this signal to the air conditioner every 3
minutes interval until press the Follow Me button again. The
air conditioner will cancel the Follow Me feature
automatically if it does not receive the signal during any 7
minutes interval.
settings.
Push this button when remote controller is on, the system
will automatically revert back to the previous settings
including operating mode, setting temperature, fan speed
level and sleep feature(if activated). And transmit the signals
to the unit.
If push this button when remote controller is off, the system
will only resume the previous settings and will not transmit
the signals to the unit. And the sleep feature is disable.
If pushing more than 2 seconds, the system will
automatically restore the current operation settings including
operating mode, setting temperature, fan speed level and
sleep feature(if activated ).

3.2. Optional operation

1. Press the SLEEP button to enable
or disable the sleep mode.
2. Press the TIMER ON and TIMER
OFF buttons to enable or disable
the timer function.
3. Press the LED button to turn on or
to turn off the display of the indoor
unit.
4. Press the TURBO button to enable
or disable the turbo function.

3.3. Special functions

AUTO mode
The unit automatically sets the
operation mode
ENGLISH 8