Replacing The Batteries; Emergency Operation - Electrolux EPI09LEIW Manual De Instrucciones

9 www.electrolux.com

3.4. Replacing the batteries

The remote control operates with two
1.5V AAA batteries.
1. Open the battery compartment.
2. Remove the old batteries.
3. Insert the new batteries. Make sure
that the positive (+) and negative (-)
markings on the batteries match the
positive (+) and negative (-)
markings on the battery
compartment.
4. Close the battery compartment.
CAUTION

Always use new batteries of the same
type. Do not use old batteries or
different batteries types.

Remove the batteries when the
remote control will not be used for a
long time.
NOTE:

Operate the remote control within its
transmitting and receiving range.

Operate the remote control at least
1 m away from your TV set or stereo
sound set.

Aim the remote control at the receiver
of the main unit to improve the
receiving sensitivity of the main unit.

If the remote control transmits a
signal, the transmitting symbol will
blink. The bell will ring if the main unit
receives the signal.

If the remote control does not operate
normally, remove the batteries and
insert them again 30 seconds later.
If the remote control still does not
operate normally, replace the
batteries.

3.5. Emergency operation

Units are equipped with a switch to run
emergency operation mode. It can be
accessed by opening the front panel.
This switch is used for manual operation
in case the remote controller fails to
work or maintenance necessary.
1. Open and lift the front panel up to an
angle until it remains fixed with a
clicking sound. For some models,
please use suspension bars to prop
up the panel.
2. One press of the manual control
switch will lead to the forced AUTO
operation. If press the switch twice
within five seconds, the unit will
operate under forced COOL operation.
To turn off the unit, press the switch
again.
3. Close the panel firmly to its original
position
NOTE

The unit must be turned off before
operating the manual control button. If
the unit is operational, continue
pressing the manual control button
until the unit is off.

To restore the remote controller
operation, use the remote controller
directly.