Switching On And Off; Sharpening A Saw Chain - FLORABEST FSG 85 D1 Traducción Del Manual Original

Wear cut-resistant safety gloves
and, if necessary, an apron
when working on the saw chain
to prevent cuts.
Keep your hands away from the
grinding disc and cutting teeth
during use. Do not move the saw
chain by hand. Risk of injury.

Switching on and off

Note: Verify the voltage specified on the
nameplate corresponds with the voltage of the
power source.
Note: Perform a test run of at least 30 seconds
without load before using this product for the
first time and after changing the grinding disc.
Switch off the product immediately if the grind-
ing disc is out of round, considerable vibration
occurs or you notice abnormal noise.
Plug the mains cable into a
socket (note the mains voltage).
Press the „I" on switch (green)
the product on.
Press the „0" off switch (red)
the product off.
The grinding disc will continue running after
switching off the tool. Risk of injury.
Note: This product is equipped with an LED
lamp. The LED lamp
19
tically when the on switch
The LED lamp is switched off automatically
when the off switch
1b
Note: This product has start-up protection: The
product will not automatically restart after auto-
matically being switched off by voltage interrup-
tion or overload protection. To switch the
product on again, press the „I" on switch
(green) and the product will start.
1a
to switch
1a
to switch
1b
is switched on automa-
is being pressed.
1a
is being pressed.

Sharpening a saw chain

(see Fig. D)
Note: Be sure to keep the vents clear when
working in dusty environments (see „Mainte-
nance and Cleaning").
If jammed, switch off the product
and unplug from the mains. Then
clear the jam.
An incorrectly sharpened saw chain may
damage the product and increase the risk
of saw kickback!
Be sure to accurately adjust the saw chain.
Observe the correct sharpening angle and
minimum chain size. Remove as little material
as possible.
Do not sharpen drive links (a) or tie straps
(b) or the saw chain may break. Failure to do
so poses a risk of accidents when using the
chain saw.
b
Note: Clean the saw chain before sharp-
ening. Clean any greasy wood residue or
oil residue with a brush or rag.
Note: All cutting links must be the same
length and width after sharpening.
Note: The saw chain is worn and must be
replaced if the cutter tooth is only approx.
4 mm.
Inserting the saw chain:
Turn the clamping lever
wise to open the chain guide. You will need
to return the clamping lever to the original
position several times to do so. To unlock
the clamping lever, pull the clamping lever
outward, then return to the original position
and allow to lock into position.
a
counter-clock-
13
GB/IE 23