Maintenance And Cleaning - FLORABEST FSG 85 D1 Traducción Del Manual Original

Afiladora para cadenas de motosierra
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63
Insert the saw chain in the chain guide
The cutting edges must face the grinding
disc
.
18a
Flip down the stop
chain toward the back until the cutting
tooth
to be sharpened makes contact
27
with the stop (see Fig. D1).
Adjusting the grinding angle:
Loosen the locking screw
essary grinding angle α on the rotary table
for the chain tensioner
Then tighten the locking screw
Note: Use the grinding angle specified by
the manufacturer.
Adjusting the stop:
Move the grinding head
handle
with the motor switched off.
4
Use the chain feed adjusting screw
move the cutting tooth
ing disc
until the cutting tooth makes
18a
contact with the grinding disc (see Fig. D2).
Secure the adjusting screw
justing nut
.
14b
Secure the links in the chain guide
turning the clamping lever
Use the adjusting screw
limiter so the grinding disc
tact with the gullet (see Fig. D2). Fix the
grinding depth with the adjusting nut
Sharpening:
Switch on the product (see chapter „Switch-
ing on and off").
Sharpen the cutting tooth
grinding head
2
pressure to the handle
Never brake the grinding disc
24 GB/IE
7
and pull the saw
15
and set the nec-
10
using the scale
12
.
10
down on the
2
to
14a
toward the grind-
27
with the ad-
14a
by
7
clockwise.
13
to set the depth
6
makes con-
18a
.
6
by moving the
27
down, applying light
.
4
to a
18a
.
stop. To prevent this, reduce the pressure
being applied in due time.
Switch the product off to move the saw
chain along. Loosen the clamping lever
and use the set stop
lever to secure the next link to be sharp-
ened in the chain guide
Note: First sharpen the teeth on one side
of the chain. Then adjust the sharpening an-
gle and sharpen the teeth on the other side.
Checking the depth limiter distance
.
11
(see Fig. D3):
The cutting parts of the saw chain are the cut-
ting links, consisting of a cutting tooth
depth limiter nose
tween these two determines the depth limiter
distance A.
Check the depth limiter distance A accord-
ing to saw chain manufacturer specifica-
tions after every third sharpening.
Rasp the height of the depth limiter nose
with a flat file and slightly round after re-
moving the depth limiter nose. The original
shape must be maintained.

Maintenance and Cleaning

Always unplug from the mains
before any adjustment, service
or repairs.
Have any work not described in these in-
structions for use performed by a specialist
workshop. Always use original parts. Allow
the product to cool down before perform-
ing any maintenance or cleaning. Risk of
burns.
Check the product for any damage such as
loose, worn or damaged parts, correctly
fastened screws or other parts, before every
use. Particularly inspect the grinding disc
Replace any damaged parts.
and the clamping
15
.
7
27
. The height distance be-
28
13
and a
28
.
18a

Publicidad

Tabla de contenido
loading

Tabla de contenido