Removing The Cybex Pallas 2-Fix; Securing The Child - CYBEX Pallas 2-fix Guia Del Usuario

Ocultar thumbs Ver también para Pallas 2-fix:
Tabla de contenido

Publicidad

REmOVING ThE CYBEX PAllAS 2-fIX

Perform all installation steps in reverse order.
– Release the iSofiX connectors (o) by simultaneously pulling and slinging
back the red release buttons (y).
– Pull the child seat out of the iSofiX-ConnECt guides (u).
– Rotate the connectors (o) by 180°.
– Pull the adjusting handle (c) located on the main frame (w) of the CYBEX Pallas
2-fix and push the connectors (o) into the child seat until they are completely
hidden.
Note!
By following these steps the vehicle's seat pad will be protected and the
iSofiX connectors will be prevented from being stained or damaged. damages and
stains could obstruct a smooth operation.

SECURING ThE ChIlD

Place the CYBEX Pallas 2-fix on the respective seat in the car.
– Please make sure that the backrest (a) of the CYBEX Pallas 2-fix rests flat against
the backrest of the car seat so that the child seat is under no circumstance in a
sleeping position.
– When using the iSofiX anchorage points (j) in the car, make sure that
the backrest (a) of the CYBEX Pallas 2-fix is perfectly aligned and in full
contact with the upright part backrest of the car seat. the position can be
adjusted with the adjusting handle (c) located under the seat cushion (d)
on the main frame (w) of the child seat.
– Should the headrest of the vehicle seat interfere, please pull it out completely,
turn it around or take it off entirely (exceptional case, refer to the section "thE
BESt PoSition in thE CaR"). the backrest (a) optimally adjusts to almost any
inclination of the vehicle seat.
Warning! The backrest of the CYBEX Pallas 2-fix should rest flat against
backrest of the car seat. Pushing the booster rearwards the seat should be
tightly pressed against the seat. for the best possible protection of your child,
the seat must be in a normal upright position!
Note!
on some car seat covers made of sensitive material (e.g. velour's, leather etc.)
the use of child seats may lead to traces of wear and tear. to avoid this, put a blanket
or a towel underneath the child seat.
12

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Solution x2-fix

Tabla de contenido