Westinghouse WH1000i Manual Del Propietário página 27

2. Clean the area around the oil fill/drain plug and
remove plug (see Figure 22).
Figure 22 – Oil Fill/Drain Plug
N OTE: The oil capacity for the 2000i series is
400 ml.
3. Using the supplied oil fill container and oil, fill the
container to the 2.0 mark on the container. Do not
overfill (see Figure 23).
2.0
1.5
1.0
0.5
Figure 23 – Oil Fill Container
OPERATION
NOTICE
Do not tilt the inverter to add oil. It must be filled on a
flat, level surface.
4. Add the 200 ml of oil to the engine
Figure 24 – Adding Engine Oil
5. Fill the container with oil again to the 2.0 mark.
6. Add the 200 ml of oil to the engine. The oil should
now be at the correct level
Figure 25 – Engine Oil Correct Level
7. Do not overfill. If oil level is too high, oil will drain out
through the fill plug.
(see Figure 24).
(see Figure 25).
27