Standby; Error Messages; Profile Setup Button Combination - Leister VARIANT T1 Manual Del Usuario

1. Work Mode

1.9 Standby

• If the welding nozzle (9) is not in the welding position and no button is pressed du-
ring a standby time defined by the user, Cool Down mode will automatically start after
the countdown has passed (Fig. 20).
The cooling down process is initiated.
• If the e-Drive
display (5) will change to Work Display (see Section 1.2 Work Display).
• Setting the standby time (Section 2.3 Standby Setup).

1.10 Error messages

• If a malfunction occurs in the hot air welding
machine VARIANT T1, a message accompanied
by an error code will appear on the display (5).
This code stands for a more precise definition of
the error which can be seen in the list below.
• Separate symbols are displayed for error 02
and error 40.
• In case of all other errors, the spanner is dis-
played for the service prompt.
Error Type of error
Err00 Control electronics defective
Err01 Interruption or short-circuit of the temperature probe
Err02 Heating element / Electronics defective (interruption in one/both winding(s))
Err04 Triac defective (one or both Triacs are defective)
Err08 Blower motor defective
Err40 Undervoltage 25% (mains voltage 75%) only VARIANT T1 230 V~
2. Profile Setup

2.1 Profile Setup Button Combination

Keep Drive and Heating buttons pressed
with main switch ON at the same time.
is pressed before the countdown has passed (180 seconds), the
ON
Release
(Fig. 20)
1
2
3
37