Introduction - Campbell Hausfeld VT639100 Manual De Instrucciones Y Lista De Piezas

Operating Instructions and Parts Manual

Introduction

Refer to Figure 1.
Pressure Switch - Auto/Off Switch - In the "Auto" position,
the compressor shuts off automatically when tank pressure
reaches the maximum preset pressure. After air is used from
the tank and drops to a preset low level, the pressure switch
automatically turns the motor back on. In the "Off" position,
the compressor will not operate. This switch should be in the
"Off" position when connecting or disconnecting the power
cord from the electrical outlet.
When the pressure switch turns the motor off you will hear air
leaking out of the pressure switch unloader valve for a short
time. This releases the air pressure from the discharge tube
and allows the compressor to restart easier.
Regulator - The regulator controls the amount of air pressure
released at the hose outlet (Sold separately).
ASME Safety Valve - This valve automatically releases air if
the tank pressure exceeds the preset maximum.
Discharge Tube - This tube carries compressed air from
the pump to the check valve. This tube becomes very hot
during use. To avoid the risk of severe burns, never touch the
discharge tube.
Check Valve - One-way valve that allows air to enter the
tank, but prevents air in the tank from flowing back into the
compressor pump.
Belt Guard - Covers the belt, motor pulley and flywheel.
Tank Drain Valve - This valve is located on the bottom of the
tank. Use this valve to drain moisture from the tank daily to
reduce the risk of corrosion.
Discharge Port (Tank Outlet) - Air delivery port for transfer
of compressed air.
Tank Pressure Gauge - Indicates the amount of air pressure
stored in the tank.
www.campbellhausfeld.com
Discharge
Tube
Tank
Pressure
Gauge
ASME
Safety
Valve
Figure 1
4
Air Filter
Belt
Guard
Pressure
Switch
Discharge
Port
Tank Drain
Valve