Operation - Defiant DF-5718-BK-D Guía Para El Uso Y Cuidado

Installation (continued)
Caulking Around the Light
5
Fixture
Caulk around the canopy (B) and mounting
surface with silicone sealant (not included).

Operation

1
Adjusting the Bulb Holders
WARNING: Risk of fire. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of fire. Keep the bulbs at least 2 in.
(51 mm) from combustible materials.
CAUTION: Keep the sensor at least 1 in. (25 mm) away
from the bulbs.
CAUTION: Keep bulb holders 30° below horizontal to
avoid water damage and electrical shock.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Loosen the lock nut (1) and thumb screw (2) to
adjust the bulb holders (A) for the desired light
coverage.
Tighten the lock nut (1) and thumb screw (2).
NOTE: Do not rotate the bulb holders more than 180°
from the factory setting.
A
B
1
2
7
6
Installing the Shells and Bulbs
Align the three slots on the shell (D) with the
three nibs on the bulb holder (A).
Insert the shell (D) into the bulb holder (A) and
twist clockwise to lock.
Repeat for the other shell (D).
Install bulbs (not included) into both bulb
holders (A).
A
Rotating Sensor Controls
2
Downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Rotate the motion sensor (C) so the controls
face toward the ground.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
Please contact 1-866-308-3976 for further assistance.
D
D
A
C
HOMEDEPOT.com