Operation - Defiant DFI-5982-WH Guía De Uso Y Cuidado

Installation (continued)
7
Caulking around the light
fixture
□
Caulk around the 1-2- asy Connect™ (D) and
mounting surface with silicone sealant (not
included).

Operation

1
Adjusting the lamp heads
WARNING: Risk of fire. Keep the lamp heads at least
2 in. (51 mm) from combustible materials.
CAUTION: Keep lamp heads 30° below horizontal to
avoid water damage and electrical shock.
□
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
□
If needed, gently grasp the lamp heads (A) and
tilt them up or down or side to side to adjust
the light coverage area.
2
Setting the sensor for testing
NOTE: When the "Auto / Test" control is set to the "Test"
position, the light fixture will operate during the day or
night. The light will stay on for 8 seconds after all motion
is stopped.
□
Turn the "Auto / Test" control fully clockwise to
the "Test" position.
□
Turn the "TIME" control fully counterclockwise
to the minimum position.
□
Turn the "SENS" control fully clockwise to the
minimum position.
D
A
□
After all adjustments are complete, turn the
"Auto / Test" control fully counterclockwise to
the "Auto" position.
NOTE: The motion sensor will need to completely warm
up (60 seconds) before beginning the setup process.
7
Please contact 1-866-308-3976 for further assistance.
C
HOMEDEPOT.COM