Operation - Defiant DF-5599-BZ-A Guía De Uso Y Cuidado

Installation (continued)
Caulking Around the Light
5
Fixture
Caulk around the canopy (B) and mounting
surface with silicone sealant (not included).

Operation

1
Adjusting the Bulb Holders
WARNING: Risk of fire. Do not aim the bulbs at a
combustible surface within 3 ft. (1 m).
WARNING: Risk of fire. Keep the bulbs at least 2 in.
(51 mm) from combustible materials.
CAUTION: Keep the sensor at least 1 in. (25 mm) away
from the bulbs.
CAUTION: Keep bulb holders 30° below horizontal to
avoid water damage and electrical shock.
Turn the power on at the circuit breaker or fuse
and turn on the wall switch.
Loosen the lock nut (1) and thumb screw (2) to
adjust the bulb holders (A) for the desired light
coverage.
Tighten the lock nut (1) and thumb screw (2).
NOTE: Do not rotate the bulb holders more than 180°
from the factory setting.
1 2
B
A
6
Replacing a Bulb
Remove the shade (4) by loosening the set
screw (5) several turns.
Turn the shade (4) counterclockwise and remove.
Pull the bulb out of the bulb holder (A) and
replace with a new bulb.
Reinstall the shade (4) to the desired position
and tighten the set screw (5).
5
Rotating Sensor Controls
2
Downward
CAUTION: To avoid water damage and risk of electrical
shock, the motion sensor controls must be facing the
ground when installation is complete.
Rotate the motion sensor (C) so the controls
face toward the ground.
NOTICE: All clearances must be maintained. See Safety Information
on page 2.
7
Please contact 1-866-308-3976 for further assistance.
4
A
C
HOMEDEPOT.com