Handle Positions; Tr A N S P O Rting Cleaner; Carpet Height Adjustment; Edge Cleaning - Hoover WindTunnel Instrucciones De Operación

1 5
A
Plug cord into electrical outlet.
1 5
To turn cleaner ON, push
switch (A) toward front of cleaner.
To turn cleaner OFF, push (A) toward
back of cleaner.
1 8
The cleaner can also be moved
1 8
by using carrying handle.
2 1
HIGH
For maximum cleaning perfor-
2 1
mance, the following carpet
height settings are re c o m m e n d e d .
• Lowest setting: for all types of carpet
• Higher settings: for very deep pile
carpet where easier pushing effort is
desired, while maintaining good
cleaning performance.
1 6

Handle Positions

The handle of your cleaner has
1 6
three positions; upright for
storage and when using cleaning
tools; operating position for gener-
al operation on carpet and floors;
low for reaching under low furniture.
Step on handle release lever to
lower handle.
1 9
B

Carpet height adjustment

The cleaning of carpet and ru g s
1 9
takes place at the nozzle (A).
When it is necessary to raise and
lower the nozzle for various carpet
pile heights, slide the nozzle control
knob (B) to the desired setting.
BARE
FLOOR
Note: If the cleaner is difficult to push,
slide knob to the next higher setting.
1 7

Tr a n s p o rting cleaner

To move your cleaner from
1 7
room to room, put handle in
upright position, tilt cleaner back on
rear wheels and push forward.
2 0
A
For ease in sliding knob, the
2 0
handle should be in the upright
position (C).
The nozzle will not move into the
adjusted position until the cleaner
handle is lowered to the operating
position (D).
2 2

Edge cleaning

Special edge groomers are pro-
2 2
vided on both sides of the nozzle
to remove dirt in carpet near base-
b o a rds and furn i t u re. Guide either side
of nozzle parallel to edge of carpet or
f u rn i t u re .
C
D
5