Specifications; Machine Assembly; Instructions For Attaching Autofeed Assembly - RIDGID Auto-Spin Manual Del Operador

Auto-Spin

Specifications

Motor Type ...................Universal
Machine Rating............115V, single phase, AC
1.1 amp, 60Hz
Power Switch ...............ON/OFF/Momentary Reverse
Operating Speed..........450 RPM
Drain Line Capacity..... 3 /
Weight .............................10 lbs.
Cable................................ 1 /
Catalogue No. 21338
AUTOFEED™
Figure 1 – Auto-Spin™ Drain Cleaner
The Auto-Spin™ is not designed for use in
CAUTION
" or for use in toilets.
drains larger than 1 1 /
2

Machine Assembly

WARNING
To prevent serious injury, proper assembly of the
Drain Cleaner is required. The following procedures
should be followed:
Instructions For Attaching Autofeed
Assembly
1. Put the tip of the cable into the guide hose (Figure 2)
and feed it through the hose to the AUTOFEED™ as-
sembly.
2. The bulb head auger will not fit through the AUTO-
FEED™ assembly. Pull up on both the FORWARD
and REVERSE levers and then feed the cable through
the AUTOFEED™. (Figure 3)
4
™ Drain Cleaning Machine
" – 1 "
1 /
4 2
" x 30' MAXCORE™
4
ON/OFF/REV
Switch
Appliance
Leakage Current
Interrupter (ALCI)
Foot Switch
Figure 2 – Feeding Cable into Guide Tube
Figure 3 – Feeding Cable Through AUTOFEED™ Assembly
3. Release the FORWARD and REVERSE levers.
4. Attach the guide hose to the machine by pushing
the hose over the nose of the drum cover. (Figure 4)
Figure 4 – Attaching Guide Hose to Machine
Ridge Tool Company