Maintenance Chart - Briggs & Stratton Snapper 7800968-01 Manual Del Operador

Tabla de contenido

Idiomas disponibles

WARNING

Grass Catcher bags are made of woven fabric, and are

subject to deterioration and wear during normal usage.

Check condition of bag before each use. Immediately

replace worn or damaged catcher bags with only genuine

replacement bags. The grass catcher is optional equipment

on some models.

Emptying the Grass Bag

1. Grasp the bag connector and bag handle. Lift up on the

bag handle, removing it from the mower handle. Then lift

up on the bag connector, removing it from the adapter

flange.

2. Open the bag by pulling the bag slider (A, Figure 15) off

of the Z-fold at the rear of the bag (B).

3. To close the bag, fold the rear of the bag into the former

Z-shape, keeping the edges aligned. Grasp the edge of

the Z-fold, and while holding the slider, pull the Z-fold fully

into the slider.

Note: An illustration of the Z-Fold is attached to the bag.

WARNING

Grass Catcher bags are made of woven fabric, and are

subject to deterioration and wear during normal usage.

Check condition of bag before each use. Immediately

replace worn or damaged catcher bags with only genuine

replacement bags. The grass catcher is optional equipment

on some models.

Maintenance

Emissions Control Service

Maintenance, replacement, or repair of the emissions

control devices and systems may be performed by

any off-road engine repair establishment or individual.

However, to obtain "no charge" emissions control service, the

work must be performed by a factory authorized dealer. See

the Emissions Control Statements.