Important Safeguards For Electrical Appliances - Gastroback Design Sandwichmaker Instrucciones De Funcionamiento

IMPORTANT SAFEGUARDS FOR ELECTRICAL APPLIANCES

The appliance is heated electrically. Place the appliance near a suita-
ble wall power outlet to connect the appliance directly to a protected
mains power supply with protective conductor (earth/ground) connected
properly. Ensure that the voltage rating of your mains power supply cor-
responds to the voltage requirements of the appliance (230 - 240 V,
50/60 Hz, AC, rated for at least 10 A). The power outlet socket must be
installed separately from other power outlet sockets to avoid interference
with other appliances.
The installation of a residual current operated circuit breaker (r.c.c.b.)
with a maximum rated residual operating current of 30 mA in the supp-
lying electrical circuit is strongly recommended. If in doubt, contact your
electrician for further information.
• In various foreign countries, the specifications for power supplies are
subject to incompatible norms. Therefore, it is possible that power sup-
plies in foreign countries do not meet the requirements for safe opera-
tion of the appliance. Thus, before operating the appliance abroad,
ensure that safe operation is possible. Do not use any desk top multi
socket outlet, external timer, or remote control systems.
• It is best to avoid using an extension cord, but if you wish to use one,
ensure that it is of sufficient length and rated for a maximum continuo-
us current of at least 10 A with safety plug, safety coupler plug, and
protective conductor (earth/ground) connected properly.
• When laying power cords, always ensure that no one will step on
the power cord or trip over the power cord, pull the appliance by the
power cord, or gets entangled. Also, ensure that no tension is applied
to any part of the power cord. Do not let the plug or power cord hang
over the edge of the table or counter. It is best to tie the extension cord
loosely onto the leg of the table using a separate cord. To disconnect:
Always unplug the extension cord from the power supply first. Always
grasp the plug for disconnecting the power cord.
• Always handle power cords with care. The pins of the power plug
must be smooth, clean, and without any discolouration. Always com-
pletely unwind the power cord before use. Do not place the appli-
EN
38