ABB 6550-500 Manual De Instrucciones página 59

Fault Elimination
30 Fault Elimination
Diagnosis
Controller constantly
adjusts lighting to
maximum brightness:
Lighting is not on:
Cause/Remedy
– Control voltage (< 1V – 10V)
not connected
– Switch supply voltage OFF/ON
– Minimum brightness still too
high; reset
– Control voltage (< 1V – 10V)
short-circuited
– Switch supply voltage OFF/ON
– Minimum brightness still too
low; reset
– Replace upstream fuse
– Replace defective fluorescent
lamp
– Replace EG
– Replace defective controller
ENG 59