Fault Elimination - ABB 6550-500 Manual De Instrucciones

Fault Elimination

Applies only to 6550U-10x-500
Diagnosis
LED of the Operating
Element (6066-xxx-
500) does not
illuminate:
LED of the 6066-xxx-
500 blinks
continuously:
LED of the 6066-xxx-
500 does not blink in
case of a transmitting
signal:
Pos: 9 /Fuer alle Dokumente/Seitenwechsel @ 0\mod53_1.doc @ 1171
Cause/Remedy
– Eliminate IR extraneous light
source
– Apply supply voltage
– Eliminate IR extraneous light
source
– Check IR signal reception
– Replace battery of the IR -
hand-held, or wall-mounted,
transmitter
– IR transmitting range has
been exceeded
ENG 60