Safety Precaution; Safe Operation - Worx BladeRunner X2 WX572 Manual Original

ADDITIONAL SAFETY
INSTRUCTIONS FOR YOUR
BLADE RUNNER

1. SAFETY PRECAUTION

1) Do not use saw blades which are damaged
or deformed;
2) Replace the table insert when worn;
3) Connect blade runner to a dust-collecting
device when sawing wood;
4) Take care that the selection of the saw
blade and the speed depends on the
material to be cut;
5) Do not clean the saw blade whilst it is in
motion;
6) Wear suitable personal protective
equipment, when necessary, this could
include:
– hearing protection to reduce the risk of
induced hearing loss;
– respiratory protection to reduce the risk of
inhalation of harmful dust;
– gloves for handling the saw blade and
rough material.
12

2. SAFE OPERATION

1) During transportation the saw blade guard
should be locked at fully down (close to the
table) position;
2) Do not use guard and its support system
for handling or transportation;
3) When cutting round timber use a suitable
holding device to prevent twisting of the
workpiece;
4) Any time after cutting, the knob for locking
blade guard shall be released so that the
guard is fully down to the table.
5) The thickness of cutting material cannot
exceed the recommended maximum
thickness. This tool cannot be used for
cutting glass or mesh wire.
BladeRunner ® X2
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Double insulation
Wear ear protection
Wear eye protection
Warning: do not expose to rain or
use in damp locations
Before any work on the machine
itself, pull the power plug from the
outlet
Wear protective gloves
Wood
Aluminium
Metal
Plastic
Ceramic tile
Teeth per inch
EN