Worx BladeRunner X2 WX572 Manual Original página 14

TROUBLE SHOOTING
Symptom
Tool will not start when
switched on.
Poor cut quality
Work efficiency is low.
Blade is not clamped tightly by
the Blade Holder.
Blade Release button cannot be
pressed down.
14
Guard Arm vibrates too much.
Rip Fence cannot slide into
Fence Slot smoothly.
BladeRunner
Possible Causes
• Power cord is not plugged
in.
• Blade is worn out.
• Blade is set incorrectly
• Too much vibration in
material.
• Too much vibration of the
saw.
• Feed rate too fast.
• Blade is worn out.
• Feed rate too fast.
• Blade is not inserted into
place fully.
• Dust accumulates.
• Screws fixing the Guard
Arm on the work table are
loose.
• Rip Fence locking knob too
tight.
® X2
Possible Solution
• Check to make sure power cord
is connected well into a working
outlet.
• Make sure the blade is sharp and
not broken.
• Make sure the blade is installed
properly.
• Tighten Guard and Guard Arm
firmly down onto material.
• Clamp or fasten saw base to
tabletop.
• Feed the material more slowly.
• Change to a new blade.
• Feed the material more slowly.
• Use blade grip to push the blade as
far into the blade holder as possible
before letting go of Blade Release.
• Clean the dust around the Blade
Release button.
• Tighten the screws as shown in
Fig A1.
• Loosen the Rip Fence locking
knob.
EN